Details - SwitchWright DCC*/Relay Switch Machine


SwitchWright DCC*/Relay Switch Machine
SwitchWright DCC*/Relay Switch Machine

Part No: TVD 030

 




SwitchWright DCC*/Relay Switch Machine

(includes PC board w/DCC* and relay, servo, bracket, fascia controller, and wire fully assembled) Perfect for throwing turnouts from below the table in scales from Z to O. Enough power for solid point rail up to code 100. Based on laser cut 1/8" plywood for toughness and durability pre-assembled with a miniature servo and a 3" long 0.032" wire. Will throw all hinged point turnouts and solid point turnouts up to code 100. Includes a Red/Green Fascia Controller. Requires 5 Volt DC power. *DCC not required - can use with DC too! Must use with 5Volts DC Power

$AUD 52.00


* Prices marked in red indicates a Discount is applied - see Clearance Page specials for more details!


More Images

SwitchWright DCC*/Relay Switch Machine
Here is how you can use a SwitchWright to drive a second slave unit and power a crossover. Press a single button or issue a single DCC command to run both turnouts of the crossover at once.

Here is how you can use a SwitchWright to drive a second slave unit and power a crossover. Press a single button or issue a single DCC command to run both turnouts of the crossover at once.